Adept Export Tablet Tools - Punches, Dies

We understand that often you have specialized requirements and to meet them we have special tooling:

Core-Rod Tooling

Core-Rod Tooling

These are useful for products that require high surface area. Typically used for confectionery products. Also used for making Tablet-in-Tablet.

Tungsten Carbide lined Dies for abrasive products

Tungsten Carbide Lined Punches & Dies

In cases when corrosive material is used or for very high volume products or products which require high compression force - the punches get corroded and a die ring is formed very fast. To avoid this wear and tear and to increase the life of the tools we use a very hard metal; Tungsten Carbide in the contact areas.

Teflon Tip Punch for sticky products like Effervescent tablets

Teflon Tip Punches

Sticking is a major problem faced while manufacturing effervescent tablets. Not only does the powder stick to the punch face but it also corrodes the tooling. To minimize these problems we use Teflon tip punches as Teflon is less prone to sticking and the disc can be replaced if damaged.

Multi-Tip tooling for small tablets

Multi-Tip Tooling

For tablets that are small in size and are required to be manufactured in huge volumes, we provide multi-tip tooling. In these tooling more than one tip is accommodated on a single punch thereby increasing production substantially.

However using this tooling requires a lot of skill and does have shorter life than normal tooling. It is recommended ideally where the tablet size is very small, hence many tips can be accommodated which would help distribute the compression force over a larger area.

Rotating Head punch for shaped tablets

Rotating Head for Shaped Punches

Shaped toolings have a shorter life than round toolings. One of the major reasons is that the wear & tear of the underside of the punch head results in weight variation. To avoid this we have created a rotating head tooling so the punch head can rotate just like round tooling and avoid this wear and tear, thereby giving it longer life.

Bakelite Punch for sticky products

Bakelite Relief / Threading on Lower Punch

For tablets that are sticky in nature, a common problem is jamming of the lower punch. The main reason for this is sticking of powder on the wall of die bore resulting in jamming of the tip in the die bore. To reduce this problem we give a sharp undercut on the punch tip, acting like a scrapping blade, which cleans the die bore at every compression.

Download Procurement Form